|Melting Point:||248°F - 271°F (120°C - 133°C)|
|Specific Gravity:||.0915 - .0965|
|Flash Point:||665°F (352°C)|
|pH:||1.5 - 7.0|
|CLEANUP:||Sweep or vacuum|
|Storage:||Keep material dry|
Air & Surface: N/A RELATIVE HUMIDITY
Can be applied up to 95%
Add 20-30% D200 to urethane by volume
Add 30-40% D200 to urethane by volume
Add 40-50% D200 to urethane by volume
|5 gallon pail||6 pounds||55|
DOT Shipping Information:
Health 1, Flammability 0, Reactivity 0, Protection B
Published technical data and instructions are subject to change without notice. Please contact your Coatings International Roofing Systems representative for the most current information.
Important: The information in this MSDS was obtained from sources which we believe are reliable.
HOWEVER, THE INFORMATION IS PROVIDED WITHOUT ANY WARRANTY, EXPRESSED, OR IMPLIED, REGARDING
The conditions or methods of handling, storage, use and disposal of the product are beyond our control, and may be beyond our knowledge. FOR THIS AND OTHER REASONS, WE DO NOT ASSUME RESPONSIBILITY AND EXPRESSLY DISCLAIM LIABILITY FOR LOSS, DAMAGE, OR EXPENSE ARISING OUT OF OR IN ANY WAY CONNECTED WITH THE HANDLING, STORAGE, USE, OR DISPOSAL OF THE PRODUCT.
This MSDS was prepared and is to be used only for this product. If apprised of changes, updated MSDS sheets will be promptly issued. Users must make their own determination regarding the suitability of the product for their own purpose prior to use.
VIEW / DOWNLOAD a printable PDF version of this document.
Components - Chemical Name & Common Names(Hazardous Components 1% or greater: Carcinogens 0.1% or greater)
|CHEMICAL NAME (COMMON NAME)||CAS #||%||OSHA PEL (PPM)||ACGIH TLV (PPM)||OTHER LIMITS RECOMMENDED|
|Does not contain hazardous ingredients||100|
|1) BOILING POINT||
|2) SPECIFIC GRAVITY||(Water = 1) .915 to .965|
|3) VAPOR PRESSURE||N/A|
|4) MELTING POINT||N/A|
|5) VAPOR DENSITY||N/A|
|6) EVAPORATION RATE||Not Applicable|
|7) SOLUBILITY IN WATER||Negligible|
|8) WATER REACTIVE||N/A|
|9) APPEARANCE & ODOR||Fluffy fibers or wet lap - no odor|
LEL: N/A UEL: N/A
Dry chemical, carbon dioxide, foam & fog, water
Oxidizing acids, some chlorinated hydrocarbons
Thermal decomposition products above 650°F: carbon, carbon dioxide, carbon monoxide
Will not occur
Seek medical assistance for further treatment, observation and support if necessary
Irrigate eye with water for 5 minutes. Seek medical attention if irritation persists.
Wash off with water
Move subject to fresh air if effects occur, consult medical personnel
No treatment required (ho harm)
Dust mask if dust is present
Goggles for dust
Sweep off and discard or wash with water.
Recycle, incinerate in approved equipment landfill.